EZI MULTI FIX
Ezi MULTI FIX is a superior range, good performance, coarse grade, water resistant, normal cementitious adhesive (C1).
Conforming to the requirements of MS ISO 13007-1, classified as type C1.
EZI MULTI FIX
Classifcation
C1
Bed Thickness
3-6mm
Usages
Offers the following benefits when mixed with either Clean Water or Latex Admixture:
- Installation of a wide range of ceramic tiles, mosaics tiles and natural stone slabs such as marbles or granites.
- Suitable for use on a variety of substrates.
Key Performance
Good Adhesion Strength
Good Compressive
Water Resistant Properties
High Durability
Non Slump Properities
Good Workability
Minimised Efflorescence
Minimal Drying Shrinkage
Product Information
Coverage
Approximate 8-9m² per bag
Mixing Ratio
Approximate. 1 pbw Water to 3 pbw Powder
Application Area
Wall, Floor, Interior, Exterior, Dry, Wet
Plot Life
Approximate 3-4 hours
Open Time
Approximate 15-20 minutes
Setting Time
Approximate 24-48 hours
Step 1 - Preparing the substrate
- Substrate must be dry, flat and free from contamination, e.g dust, grease, laitance, oil, paint, etc.
Step 2 - Preparing the mix
- Mix adhesive with water or latex admixture until a smooth, non-slump paste is achieved (in accordance to recommended mixture ratio).
- Allow the paste to rest for approximately 10 minitues, then re-stir before using it.
Step 3 - Spreading the mix
- Spread the paste to the substrate at bed thickness of 3-6mm (may vary depending on tile size and weight) with appropriate notched trowel. It also applicable up to 12mm in small isolated areas.
- Spread no more than 1m² at a time to prevent skin-over.
Step 4 - Installing the tile
- Tiles should be fixed dry, they should not be soaked. Recommended to use damp cloth to clean the dusty tile back.
- Tiles should be installed under a firm pressure, and followed by slight twisting action to ensure good coverage and contact of the adhesive (Solid Bed Fixing).
- Tiles must be installed on the fresh adhesive bed with its recommended open time before skin-over of the adhesive occurs.
- Allocate tile joints of approximately 3mm wide between tiles.
- Remove surplus adhesuve from tile surface and joints before it hardens.
- Tiling installed must be protected from water and rain for at least 24 hours.
Highly Recommended - EZI MULTI FIX
mix with EziMix STAR AD-1 to achieve optimum performance for installation of low water absorption tiles (≤5%) in very demanding situation (e.g. swimming pools, bathrooms, etc)