EZI GROUT FINE
Fine grade, high compressible, water resistant, coloured cementitious grout. Suitable for grouting tile joint up to 5mm wide
Product Information
Classification
CG 1
Packing
Shelf Life
6 Months
Application Data
Application Area
Wall, Floor, Interior, Exterior, Dry, Wet
Mixing Ratio
Approximate 1 pbw Latex Admixture to 2.5 pbw. Grout Fine
Pot Life
Approximate 45 minutes
Setting Time
Approximate 24-48 hours
Colour
| Consumption Table | |||
|---|---|---|---|
| Size of tile (mm) | Width of the joint (mm) | ||
| 2 | 3 | 5 | |
| 25 × 25 × 4.0 | 1.09 | 1.63 | 2.72 |
| 51 × 51 × 5.0 | 0.67 | 1.00 | 1.67 |
| 108 × 108 × 4.0 | 0.25 | 0.38 | 0.63 |
| 150 × 150 × 5.5 | 0.25 | 0.37 | 0.62 |
| 200 × 200 × 7.5 | 0.26 | 0.38 | 0.64 |
| 200 × 300 × 7.5 | 0.21 | 0.32 | 0.53 |
| 300 × 300 × 8.0 | 0.18 | 0.27 | 0.45 |
| 300 × 600 × 9.0 | 0.15 | 0.23 | 0.38 |
| 400 × 400 × 10.0 | 0.17 | 0.23 | 0.43 |
| 450 × 450 × 12.0 | 0.18 | 0.27 | 0.45 |
| 500 × 500 × 12.0 | 0.16 | 0.24 | 0.41 |
| 600 × 600 × 12.0 | 0.14 | 0.20 | 0.34 |
| 800 × 800 × 12.0 | 0.10 | 0.15 | 0.26 |
Coverage Calculation Formula
(A + B) × C × D × 1.7
(A × B)
=
kg/m²
*Unit = mm
Estimated Consumption:
0.00 kg/m²
Installation Guide
Step 1 - Preparing the joint
- Allow the adhesive bed to set at least 24 hours before commencing grouting.
- Joints must be dry, flat and free from contamination, e.g dust, grease, laitance, oil, paint, etc.
Step 2 - Preparing the mix
- Mix cementitious grout with water or latex admixture until uniform colour and thin creamy paste is achieved (in accordance to recommended mixture ratio).
Step 3 - Spreading the mix
- Apply grout with rubber squeegee or float, working the grout back and forth to ensure that joints are fully filled and compacted
Step 4 - Finishing the grout
- Clean and remove surplus grout with a clean damp cloth or sponge before it dies out.
- Allow grout to set for 24 to 48 hours before subjected to service condition.
Highly Recommended - EZI GROUT FINE
mix with EziMix GT-1 to achieve optimum performance for installation of low water absorption tiles (≤5%) in very demanding situation (e.g. swimming pools, bathrooms, etc)