EZI PLASTER BASE
Coarse grade, polymer modified, high performance, premixed cement based skim coat plaster. Suitable to use for leveling, resurfacing, patching and finishing of wall before commencing EZI PLASTER FINISH and etc.
EZI PREMIX MODIFIED 103
EZI PLASTER BASE
Thickness between 2 - 4 mm per layer
EZI PLASTER FINISH
Usages
Offers the following benefits when mixed with clean water. Suitable to use for:
- Levelling, re-surfacing, patching and finishing of walls, ceilings and soffits.
- Internal areas over concrete, cement-sand render, block wall and etc
Key Performance
Good Compressive
Good Flexural Strength
Minimised Cracks
Greater Bonding Strength
Good Workability
Water Resistant Properties
Minimal Drying Shrinkage
Colour
Grey
White
Product Information
Application Area
Wall, Floor, Interior, Exterior, Dry, Wet
Mixing Ratio
33-35pbw. of water for 100pbw. of powder
Coverage
Approximate 21m² per bag at thickness 1mm
Plot Life
Approximate 1-2 hours
Open Time
Setting Time
Approximate 24-48 hours
Step 1 - Surface Preparation
- Ensure wall is dry,clean and free from dust, oil or loose particles
- Check wall flatness using a straightedge (≤ 4mm gap for 3m length)
- Dampen surface if highly absorbent.
Step 2 - Preparing the mix
- Mix with recommended ratio until smooth, consistent and creamy paste
- Mechanical mixing is recommended
Step 3 - Apply/Spreading the mix
- Using steel trowel / plastering trowel to spread the plaster mortart onto substrate.
- Apply evenly and press firmly onto substrate
- Apply at 2–4mm per layer
- Apply additional layers only after previous layer dries
Step 4 - Level and Smooth
- Level and smooth using steel trowel
- Ensure surface is flat and consistent.
- Allow initial set (~24 hours)
Step 5 - Finishing
- Allow curing for 1–2 weeks before painting / finishing
- Ready for final coating (paint / plaster finish / etc.)