EZI PREMIX MODIFIED RENDER 103
High performance, modified cement sand rendering mortar. Suitable to use for patching, brick wall, concrete wall, blocks and etc.
Concrete
Slurry Bond Coat
EZI PREMIX MODIFIED RENDER 103
EZI PREMIX MODIFIED 103
EZI PLASTER BASE
EZI PLASTER FINISH
Usages
EZI PREMIX MODIFIED RENDER 103 is specially developed for:
- Wall Rendering/Levelling Mortar onto wall, brick wall and etc as render coat underneath to receive Ezi Tile Adhesive, Plaster Base and Plaster Finish, paint or etc.
Key Performance
Good Compressive
Good Flexural Strength
Minimised Cracks
Greater Bonding
Good Workability
Water Resistant
Reduce Drying Shrinkage
Product Information
Application Area
Wall, Floor, Interior, Exterior, Dry, Wet
Mixing Ratio
Approximate 1 pbw Latex Admixture to 2.5 pbw. Grout Fine
Coverage
Plot Life
Approximate 45 minutes
Open Time
Setting Time
Approximate 24-48 hours
Step 1 - Surface Preparation
- Ensure wall is dry,clean and free from dust, oil or loose particles
- Check wall flatness using a straightedge (≤ 4mm gap for 3m length)
- Dampen surface if highly absorbent.
Step 2 - Preparing the mix
- Mix with recommended ratio until smooth, consistent and creamy paste
- Mechanical mixing is recommended
Step 3 - Apply/Spreading the mix
- Using steel trowel / plastering trowel to spread the plaster mortart onto substrate.
- Apply evenly and press firmly onto substrate
- Apply at 2–4mm per layer
- Apply additional layers only after previous layer dries
Step 4 - Finishing
- Allow curing for 1–2 weeks before painting / finishing
- Ready for final coating (paint / plaster finish / etc.)