EZI WP SLURRY C077

EziWP SLURRY C077 is a semi-flexible, two component, latex fortified cementitious waterproofing slurry. It affords protection to a variety of building application with excellent reduction in water penetration.

Product Information

Packing

Part A - Powder (20KG)
Part B - Liquid (6KG)

Shelf Life

12 Months

Application Data

Application Area

Wall, Floor, Interior, Exterior, Dry, Wet

Mixing Ratio

Part A 20KG Powder to Part B 6KGLiquid

Waiting TIme between coats

Approx. 2 – 3 hours

Coverage

2 Coats: Approx. 1.5 – 2.0kg / m²
3 Coats: Approx. 2.0 – 2.5kg / m²

Final coating thickness

2 Coats: Approx. 1.5 – 2.0mm
3 Coats: Approx. 2.0 – 2.5mm

Usages

Recommended Ezi waterproofing solutions for under tiles or render/screed applications:

Toilet

Bathroom

Swimming pools

Wet Kitchen

Laundry & Drying Yard

Refuse Chamber

Balconies

RC Gutter

Installation Guide

Concrete

EZIWP SLURRY C077

EZI PREMIX MODIFIED RENDER 103

EZI PREMIX MODIFIED RENDER 104

KEY FEATURE OF EZI WP SLURRY C077 :

  • SemiFlexible
  • Execellent bonding to well prepared & sound substrate
  • Eco-Friendly - Low VOC & Non-Toxic
  • Pre-packed compenents - Avoid mixing error
  • Slurry consistency - Ease of application
  • Protect against water penetration
  • Protect against concrete carbonation
  • Non-corrosive

Step 1 - Preparing the substrate

  • Ensure the substrate is dry, sound and free from contamination, e.g dust, grease, laitance, oil, loose particle, etc.

Step 2 - Preparing the mix

  • Mix EZI WP SLURRY C077 PART A AND PART B until a consistent slurry is achieved. (in accordance to recommended mixture ratio).

Step 3 - Applying the mix - First Coat

  • Apply EZI WP SLUPPRY C077 consistently onto the substrate using stiff brush, large format brush/roller.
  • Treat all the joints and corners first before apply extended throughout the entire areas.
  • Apply first coat throughout the selected area and allow it to cure until touch-dry condition before second coat commence.

Step 4 - Applying the Mix - Second Coat snf Finishing

  • Before first coat is fully cured, apply second coat over the first coat at opposite direction to provide a strong mechanism waterproofing layer.
  • Allow the applied waterproofing layer to cure for at least 24-48 hours.
  • The ideal thickness for cured layer(2 coats) is approximately 1-2mm.

Downloads

Technical Data Sheet (TDS)
Safety Data Sheet (SDS)