EZI WP SLURRY C177

Ezi WP SLURRY C177 is a semi-exible, two component, latex fortied cementitious waterproong slurry. It affords protection to a variety of building application with excellent reduction in water penetration.

EZI WP SLURRY C177

Concrete

Usages

Specially designed for waterproofing under tiles or render/screed in:

  • Toilet
  • Bathroom
  • Swimming Pools
  • Wet Kitchen
  • Laundry & Drying Yard
  • Refuse Chamber
  • Balconies
  • RC Gutter

Key Features

  • SemiFlexible
  • Execellent bonding to well prepared & sound substrate
  • Eco-Friendly – Low VOC & Non-Toxic
  • Pre-packed compenents – Avoid mixing error
  • Slurry consistency – Ease of application
  • Protect against water penetration
  • Protect against concrete carbonation
  • Non-corrosive

Product Information

Application Area

Wall, Floor, Interior, Exterior, Dry, Wet

Mixing Ratio

Part A 15KG Powder to Part B 6KG Liquid

Coverage

2 Coats: Approx. 6 – 7 m² at 2mm coating thickness

Final Coating Thickness

2 Coats: Approx. 1.5 – 2.0mm
3 Coats: Approx. 2.0 – 2.5mm

Waiting Between Coat

Approx. 2 – 3 hours

Step 1 - Preparing the substrate

  • Ensure the substrate is dry, sound and free from contamination, e.g dust, grease, laitance, oil, loose particle, etc.

Step 2 - Preparing the mix

  • Mix EZI WP SLURRY C077 PART A AND PART B until a consistent slurry is achieved. (in accordance to recommended mixture ratio).

Step 3 - Applying the mix - First Coat

  • Apply EZI WP SLUPPRY C077 consistently onto the substrate using stiff brush, large format brush/roller.
  • Treat all the joints and corners first before apply extended throughout the entire areas.
  • Apply first coat throughout the selected area and allow it to cure until touch-dry condition before second coat commence.

Step 4 - Applying the Mix - Second Coat snf Finishing

  • Before first coat is fully cured, apply second coat over the first coat at opposite direction to provide a strong mechanism waterproofing layer.
  • Allow the applied waterproofing layer to cure for at least 24-48 hours.
  • The ideal thickness for cured layer(2 coats) is approximately 1-2mm.

Downloads

Technical Data Sheet (TDS)
Safety Data Sheet (SDS)