EZI BIG FIX

Ultra-thick bed (6-15mm), single part, larex modified, flexible cementitious adhesive with high compressive properties and extended open time for installing large format tiles and heavy duty stones at floor areas.

EZI BIG FIX

Classifcation

C2 E

Bed Thickness

6-15mm

Usages

Offers the following benefits when mixed with either Clean Water:

  • Installation of a wide range of ceramic tiles, mosaics tiles and natural stone slabs such as marbles or granites.
  • Suitable for use on a variety of substrates.

Key Performance

High Adhesion​

High Compressive​

Good Slip Resistance

Extended Open​

High Durability

For Big Tiles & Stones

Non Slump Properities

Good Workability

Water Resistant Properties

Minimal Drying Shrinkage

Product Information

Coverage

Approximate 4-5m² per bag

Mixing Ratio

Approximate 1 pbw Water to 3 pbw Powder

Application Area

Wall, Floor, Interior, Exterior, Dry, Wet

Plot Life

Approximate 3-4 hours

Open Time

Approximate 15-20 minutes

Setting Time

Approximate 24-48 hours

Step 1 - Preparing the substrate

  • Substrate must be dry, flat and free from contamination, e.g dust, grease, laitance, oil, paint, etc.

Step 2 - Preparing the mix

  • Mix adhesive with water or latex admixture until a smooth, non-slump paste is achieved (in accordance to recommended mixture ratio).
  • Allow the paste to rest for approximately 10 minitues, then re-stir before using it.

Step 3 - Spreading the mix

  • Spread the paste to the substrate at bed thickness of 3-6mm (may vary depending on tile size and weight) with appropriate notched trowel. It also applicable up to 12mm in small isolated areas.
  • Spread no more than 1m² at a time to prevent skin-over.

Step 4 - Installing the tile

  • Tiles should be fixed dry, they should not be soaked. Recommended to use damp cloth to clean the dusty tile back.
  • Tiles should be installed under a firm pressure, and followed by slight twisting action to ensure good coverage and contact of the adhesive (Solid Bed Fixing).
  • Tiles must be installed on the fresh adhesive bed with its recommended open time before skin-over of the adhesive occurs.
  • Allocate tile joints of approximately 3mm wide between tiles.
  • Remove surplus adhesuve from tile surface and joints before it hardens.
  • Tiling installed must be protected from water and rain for at least 24 hours.

Downloads

Technical Data Sheet (TDS)
Safety Data Sheet (SDS)