EZI PREMIX MODIFIED MORTAR 104
Coarse grade, polymer modified, high performance, premixed cement based skim coat plaster. Suitable to use for leveling, resurfacing, patching and finishing of wall before commencing EZI PLASTER FINISH and etc.
EZI PREMIX MODIFIED MORTAR 104
Slurry Bond Coat
Concrete
Tile Adhesive
Tile Grout Fine
Usages
EZI PREMIX MODIFIED MORTAR 104 is specially developed for:
- Floor Screeding/Leveling Mortar onto RC slab as a screed base to receive Ezi Tile Adhesive, texcrete & etc.
- Ideal for floor screed at thickness of :
- Bonded Screed : 25mm-40mm
- Unonded Screed : 50mm or above
- Floating Screed : Less than 75mm
Key Performance
High Compressive Strength
High Adhesion Strength
Minimised Cracks
High Abrasion
Minimised Efflorescence
Reduce Drying Shrinkage
Product Information
Application Area
Wall, Floor, Interior, Exterior, Dry, Wet
Mixing Ratio
33-35pbw. of water for 100pbw. of powder
Coverage
Approximate 21m² per bag at thickness 1mm
Plot Life
Approximate 1-2 hours
Open Time
Setting Time
Approximate 24-48 hours
Step 1 - Surface Preparation
- Ensure wall is dry,clean and free from dust, oil or loose particles
- Check wall flatness using a straightedge (≤ 4mm gap for 3m length)
- Dampen surface if highly absorbent.
Step 2 - Preparing the mix
- Mix with recommended ratio until smooth, consistent and creamy paste
- Mechanical mixing is recommended
Step 3 - Apply/Spreading the mix
- Using steel trowel / plastering trowel to spread the plaster mortart onto substrate.
- Apply evenly and press firmly onto substrate
- Apply at 2–4mm per layer
- Apply additional layers only after previous layer dries
Step 4 - Finishing
- Allow curing for 1–2 weeks before painting / finishing
- Ready for final coating (paint / plaster finish / etc.)